Evinrude E-NATION, for those dedicated to water, power, fishing and fun
Reply
Highlighted
Mate
Posts: 2
Registered: a month ago

E tec 25hp

My 2018 25hp etec just recently started to bog down and go into saftey mode or whatever. I'd been running it for about 30 min or so and it bogged down and went into saftey mode or just idled. I turned it off for 5 min started it back up and ran for about 5 min then it bogged down then run it for another 5 min then it'd do it again over and over. No LED light stayed on to show me if anything was wrong. I'm lost any help would be appreciated
Admiral
Posts: 7,257
Registered: ‎07-14-2011

Re: E tec 25hp

 

 

The nice thing about this website is that you do not have to ask the same question multiple times to receive and answer. Please read our response to your query in the other forum where you posted. Thank you.

 

 

 


"There is never just one thing wrong with a boat";
                    -- Travis McGee, main character in a book series by John D. McDonald 


 



***************

The factory recommends that a properly trained technician service your Johnson or Evinrude outboard motor. Should you elect to perform repairs yourself, use caution, common sense, and observe safety procedures in the vicinity of flammable liquids, around moving parts, near high-temperature components, and working with electrical or ignition systems.

The information offered here is only general in nature and should not be construed as complete factory approved procedures, techniques, or specifications. Always use the proper service manual for your motor, up-to-date service literature, the correct tools, and have an understanding of how to proceed with troubleshooting and repair methods. If you are unsure or uncomfortable with a procedure, a situation, or a technique, enlist the services of a factory trained technician.