Evinrude E-NATION, for those dedicated to water, power, fishing and fun
Reply
Highlighted
Skipper
Posts: 6
Registered: ‎03-14-2020

System Check Gauge.

Does anyone know the part number for the harness that plugs into the back of the 8 pin 2 inch round system check gauge.
Highlighted
Admiral
Posts: 9,515
Registered: ‎07-14-2011

Re: System Check Gauge.

What length do you need as it has to run from inside the engine, snaked through the boat, and up to the console?

 

 

System_Check Boat Wiring_Harness_Colors.jpg

 

 

 


"There is never just one thing wrong with a boat";
                    -- Travis McGee, main character in a book series by John D. McDonald 


 



***************

The factory recommends that a properly trained technician service your Johnson or Evinrude outboard motor. Should you elect to perform repairs yourself, use caution, common sense, and observe safety procedures in the vicinity of flammable liquids, around moving parts, near high-temperature components, and working with electrical or ignition systems.

The information offered here is only general in nature and should not be construed as complete factory approved procedures, techniques, or specifications. Always use the proper service manual for your motor, up-to-date service literature, the correct tools, and have an understanding of how to proceed with troubleshooting and repair methods. If you are unsure or uncomfortable with a procedure, a situation, or a technique, enlist the services of a factory trained technician.